Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR › 2011.10–2015.04
RM19V0EQ _59 Vehicle Exterior _014620 WIPER / WASHER _0074243 WASHER MOTOR A

WIPER / WASHER  WASHER MOTOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 53851Z 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

a.
E226631

Remove the 3 screws and front wheel opening extension pad RH.


Hide 53875A 3.REMOVE FRONT FENDER LINER RH

a.
E231344

Remove the clip.


b.
E226453
1.542,2.417 1.875,2.74 0.333,0.323 10 *a
*a 90°


Using a screwdriver, turn the pin 90 degrees counterclockwise and remove the pin hold clip.


c.
E226455
1.021,1.885 1.156,1.885 true 1,2.146 1,2.5 false 0.906,2.5 1.083,2.646 0.177,0.146 10 false *1 1.188,1.792 1.406,1.969 0.219,0.177 10 true *1
*1 Grommet


Remove the 5 screws.


d.

Remove the 4 clips, 2 grommets and front fender liner RH.

HINT:

The grommets need to be replaced with new ones because they will break when they are removed.



Hide 4.DRAIN WASHER FLUID

a.
E228031

Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.

HINT:

Use a container to collect the washer fluid.



Hide 85310 5.REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
E228033

Disconnect the connector.


b.

Remove the windshield washer motor and pump assembly as shown in the illustration.