Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE › 2011.10–2015.04
RM19V0EQ _59 Vehicle Exterior _014620 WIPER / WASHER _0074244 WASHER NOZZLE G

WIPER / WASHER  WASHER NOZZLE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85035 1.INSPECT WASHER NOZZLE SUB-ASSEMBLY

a.

With the ignition switch ON, check the position that the washer fluid hits the windshield.

Standard:

Washer fluid hits the windshield in the areas shown in the illustration.


E226091
5.063,2.479 5.281,2.479 false 4.813,3.323 5.042,3.323 false 5.438,4.25 5.021,4.25 false 1.875,2.479 2.083,2.479 false 2.125,3.323 2.354,3.323 false 2.146,4.25 1.729,4.25 false 4.083,1.188 4.24,1.375 0.156,0.188 10 false A 2.979,1.188 3.135,1.375 0.156,0.188 10 false A 4.667,4.594 4.854,4.781 0.188,0.188 10 false B 3.875,5.573 4.01,5.729 0.135,0.156 10 false C 3.198,5.573 3.333,5.729 0.135,0.156 10 false C 2.094,2.365 2.271,2.563 0.177,0.198 10 false *a 2.365,3.208 2.542,3.406 0.177,0.198 10 false *b 1.583,4.146 1.781,4.323 0.198,0.177 10 false *c 4.906,2.396 5.083,2.594 0.177,0.198 10 false *a 4.667,3.25 4.844,3.448 0.177,0.198 10 false *b 5.448,4.156 5.646,4.333 0.198,0.177 10 false *c
*a Upper Limit *b Standard
*c Lower Limit - -


Standard Clearance
Area Measurement Area Measurement
A 300.0 mm (11.8 in.) B 145.0 mm (5.71 in.)
C 170.0 mm (6.69 in.) - -

HINT:

If the result is not as specified, replace the washer nozzle sub-assembly.