Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM19V0EQ _59 Vehicle Exterior _014620 WIPER / WASHER _0074246 RAIN SENSOR A

WIPER / WASHER  RAIN SENSOR  REMOVAL  


PROCEDURE

Hide 89943 1.REMOVE RAIN SENSOR COVER

a.
E235210

Disengage the 2 claws and remove the rain sensor cover as shown in the illustration.


Hide 89941 2.REMOVE RAIN SENSOR

a.
E235211

Disconnect the connector.


b.
E235212
1.208,1.688 0.635,1.688 false 1.177,1.906 1.396,2.104 0.219,0.198 10 false (1) 2.448,1.583 2.667,1.781 0.219,0.198 10 false (2) 0.479,1.583 0.635,1.75 0.156,0.167 10 false *1
*1 Stopper


Release the stopper by pulling the stopper down and remove the rain sensor as shown in the illustration.


Hide 3.CLEAN WINDSHIELD GLASS

HINT:
·

Rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.

·

Check that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue before installing the rain sensor.