Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM19V0EQ _59 Vehicle Exterior _014620 WIPER / WASHER _0074246 RAIN SENSOR G

WIPER / WASHER  RAIN SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89941 1.INSPECT RAIN SENSOR

a.
E169141
1.469,1.438 2,1.708 0.531,0.271 2,2.406 2.521,1.854 false 1.604,2.406 1.073,1.844 false 1.625,1.49 1.958,1.708 0.333,0.219 10 false S1 0.927,1.667 1.281,1.865 0.354,0.198 10 false ES 2.469,1.688 2.979,1.969 0.51,0.281 10 false SIG 0.375,0.344 0.74,0.604 0.365,0.26 10 false *a
*a Front view of wire harness connector
(to Rain Sensor)


Disconnect the S1 rain sensor connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
S1-4 (SIG) - S1-2 (ES) Ignition switch ON 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
S1-2 (ES) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the harness or connector.


d.
E141656
0.563,1.615 1.031,1.875 0.469,0.26 1.948,1.979 2.26,1.563 false 1.688,1.417 1.813,1.979 false 0.313,0.229 0.688,0.542 0.375,0.313 10 false *a 2.177,1.396 2.75,1.698 0.573,0.302 10 false MPX 1.583,1.25 2.021,1.51 0.438,0.26 10 false ES 0.698,1.656 1.083,1.958 0.385,0.302 10 false S1
*a Component with harness connected
(Rain Sensor)


Reconnect the rain sensor connector.


e.

Connect an oscilloscope to the rain sensor connector.


f.

Check for pulses.

OK:
Tester Connection Condition Specified Condition
S1-1 (MPX) - S1-2 (ES) Ignition switch ON Pulse generation


If the result is not as specified, the rain sensor may have a malfunction.