DESCRIPTION
Automatic high beam system data and the Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and to repair.
CHECK DLC3
Check the DLC3 (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION).
INSPECT BATTERY VOLTAGE
Measure the battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery.
DIAGNOSIS SYSTEM
| *1 | Automatic High Beam Indicator Light |
When the automatic high beam system malfunctions, the automatic high beam indicator light (yellow) will be turned on.
In this case, the main body ECU (multiplex network body ECU) stores DTCs (See page Vehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR).
When the system returns to normal, the automatic high beam indicator light (yellow) will be canceled.