These DTCs are stored when the CAN communication system is malfunctioning.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073 | Control Module Communication Bus Off | Control module communication bus off | CAN communication system |
| U0100 | Lost Communication with ECM | Lost communication with ECM | CAN communication system |
| U0101 | Lost Communication with TCM | Lost communication with TCM | CAN communication system |
| U0126 | Lost Communication with Steering Angle Sensor Module | Lost communication with steering angle sensor | CAN communication system |
| U0129 | Lost Communication with Skid Control ECU | Lost communication with skid control ECU | CAN communication system |
| U0142 | Lost Communication with Main Body ECU | Lost communication with main body ECU (multiplex network body ECU) | CAN communication system |
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING