Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY
RM19V0EQ _59 Vehicle Exterior _014621 LIGHTING (EXT) _0074253 REAR COMBINATION LIGHT ASSEMBLY G

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR COMBINATION LIGHT ASSEMBLY LH

a.
E220289
0.179,0.157 0.334,0.308 0.156,0.15 10 *a 0.769,1.412 0.906,1.563 0.137,0.15 10 B 1.489,0.33 1.952,0.615 0.463,0.286 1.614,0.387 1.831,0.543 0.217,0.156 10 T8 1.489,2.238 1.952,2.523 0.463,0.286 1.614,2.295 1.831,2.451 0.217,0.156 10 T9 0.94,1.497 1.481,1.497 false 2.502,1.412 2.618,1.563 0.116,0.15 10 E 2.462,1.497 1.921,1.497 false 0.692,3.303 0.808,3.453 0.116,0.15 10 E 0.854,3.387 1.395,3.387 false 2.64,3.303 2.929,3.453 0.289,0.15 10 STP 2.6,3.387 2.058,3.387 false 2.64,2.787 2.82,2.938 0.181,0.15 10 TL 2.6,2.872 1.732,3.284 false
*a Front view of wire harness connector
(to Rear Combination Light Assembly LH)


Disconnect the connector from the rear combination light assembly LH.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
T8-1 (B) - T8-2 (E) Turn signal switch in neutral position Below 1 V
Turn signal switch in left turn position 11 to 14 V (60 to 120 times per minute)
T9-2 (TL) - T9-1 (E) Light control switch off Below 1 V
Light control switch in tail position 11 to 14 V
T9-3 (STP) - T9-1 (E) Brake pedal released Below 1 V
Brake pedal depressed 11 to 14 V


If the result is not as specified, repair or replace the wire harness or connector.


Hide 2.INSPECT REAR COMBINATION LIGHT ASSEMBLY RH

a.
E220289
0.179,0.157 0.334,0.308 0.156,0.15 10 *a 0.787,1.412 0.923,1.563 0.137,0.15 10 B 1.489,0.33 1.952,0.615 0.463,0.286 1.579,0.387 1.876,0.543 0.297,0.156 10 T13 1.489,2.238 1.952,2.523 0.463,0.286 1.579,2.295 1.876,2.451 0.297,0.156 10 T12 0.94,1.497 1.481,1.497 false 2.502,1.412 2.618,1.563 0.116,0.15 10 E 2.462,1.497 1.921,1.497 false 0.692,3.303 0.808,3.453 0.116,0.15 10 E 0.854,3.387 1.395,3.387 false 2.64,3.303 2.929,3.453 0.289,0.15 10 STP 2.6,3.387 2.058,3.387 false 2.64,2.787 2.82,2.938 0.181,0.15 10 TL 2.6,2.872 1.732,3.284 false
*a Front view of wire harness connector
(to Rear Combination Light Assembly RH)


Disconnect the connector from the rear combination light assembly RH.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
T13-1 (B) - T13-2 (E) Turn signal switch in neutral position Below 1 V
Turn signal switch in right turn position 11 to 14 V (60 to 120 times per minute)
T12-2 (TL) - T12-1 (E) Light control switch off Below 1 V
Light control switch in tail position 11 to 14 V
T12-3 (STP) - T12-1 (E) Brake pedal released Below 1 V
Brake pedal depressed 11 to 14 V


If the result is not as specified, repair or replace the wire harness or connector.