Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM19V0EQ _59 Vehicle Exterior _014621 LIGHTING (EXT) _0074258 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 55900 1.INSPECT AIR CONDITIONING CONTROL ASSEMBLY (HAZARD SWITCH)

a.
E216456
2.037,0.405 2.342,0.578 0.306,0.173 10 HAZ 0.965,0.405 1.306,0.578 0.34,0.173 10 GND 0.166,0.147 0.666,0.32 0.5,0.173 10 *a 1.248,0.599 1.566,1.158 false 2.151,0.599 1.833,1.158 false
*a Component without harness connected
(Air Conditioning Control Assembly (Hazard Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (HAZ) - 6 (GND) Hazard switch off 10 kΩ or higher
Hazard switch on Below 1 Ω


If the result is not as specified, replace the heater control switch board (for Automatic Air Conditioning System).

If the result is not as specified, replace the air conditioning control assembly (for Manual Air Conditioning System).