84152
1.INSPECT HEADLIGHT LEVELING SWITCH
Voltage Check
| *a | Component without harness connected
(Headlight Leveling Switch) |
Connect a positive (+) lead from the battery to terminal 1 (B) and a negative (-) lead to terminal 4 (E).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
|---|---|---|
| 2 (T) - 4 (E) | 0 | 10.44 to 11.16 V |
| 1 | 8.52 to 9.24 V | |
| 2 | 6.6 to 7.32 V | |
| 3 | 4.68 to 5.4 V | |
| 4 | 2.76 to 3.48 V | |
| 5 | 0.84 to 1.56 V |
Battery voltage is 12 V.
If the result is not as specified, replace the headlight leveling switch.
| *a | Component without harness connected
(Headlight Leveling Switch) |
LED Illumination Inspection
Apply battery voltage to the headlight leveling switch and check that the switch illuminates.
| Tester Connection | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 4 (E) |
Illuminates |
If the result is not as specified, replace the headlight leveling switch.