Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM19V0EQ _59 Vehicle Exterior _014621 LIGHTING (EXT) _0074260 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


PROCEDURE

Hide 84340 1.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.
E167768

Insert the stop light switch assembly until the threaded sleeve hits the pedal.

NOTICE:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



b.
E236346E01
1.552,1.938 1.865,2.177 0.313,0.24 10 a

Make a quarter turn clockwise to install the stop light switch assembly.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)

or less


NOTICE:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



c.

Connect the connector.


d.

Check the protrusion of the plunger.

Protrusion of the plunger
Area Measurement
a 1.5 to 2.5 mm (0.0591 to 0.0984 in.)

If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary.

for LHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL(for LHD)>ADJUSTMENT

for RHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL(for RHD)>ADJUSTMENT

NOTICE:

Do not depress or support the brake pedal.