Home › Vehicle Exterior › HORN › RELAY
RM19V0EQ _59 Vehicle Exterior _014622 HORN _0074266 RELAY G

HORN  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 86530 1.INSPECT HORN RELAY

a.
E226254
2.896,0.792 3.177,0.792 false 3.177,1.125 2.781,1.125 false 2.031,0.792 2.323,0.792 false 3.177,1.563 2.781,1.563 false 1.927,0.698 2.073,0.896 0.146,0.198 10 1 3.208,0.708 3.396,0.948 0.188,0.24 10 2 3.208,1.021 3.427,1.302 0.219,0.281 10 5 3.188,1.49 3.375,1.781 0.188,0.292 10 3

Remove the horn relay.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the horn relay.