1.REMOVE RADIATOR GRILLE SUB-ASSEMBLY
2.REMOVE FRONT BUMPER ASSEMBLY
| *1 | Protective Tape |
Put protective tape around the front bumper assembly.
Use the same procedure for the RH side and LH side.
| *1 | Pin Hold Clip |
Using a screwdriver, turn the pins 90 degrees and remove the pin hold clip.
Use the same procedure for the RH side and LH side.
Remove the clip.
Use the same procedure for the RH side and LH side.
Remove the 6 screws.
Disengage the 3 claws.
Use the same procedure for the RH side and LH side.
for Sport Package:
Pull back the side of the front bumper assembly as shown in the illustration and disconnect each connector.
Do not apply excessive force when separating the front bumper assembly.
Use the same procedure for the RH side and LH side.
Using a clip remover, remove the 3 clips.
Remove the front bumper assembly.