Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER › 2011.10–2015.04
RM19V0EQ _59 Vehicle Exterior _014623 EXTERIOR PANELS / TRIM _0074268 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  REASSEMBLY  


PROCEDURE

Hide 52023 1.INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY

a.
B293805

Install the rear bumper reinforcement sub-assembly with the 6 nuts.

Torque:
61 N*m (622 kgf*cm, 45 ft.*lbf)


Hide 61648H 2.INSTALL WHEEL HOUSE REINFORCEMENT LH

a.
B280052

Install the wheel house reinforcement LH with the screw and nut.


b.

Engage the clip.


Hide 61647F 3.INSTALL WHEEL HOUSE REINFORCEMENT RH

HINT:

Use the same procedure as for the LH side.


Hide 52576 4.INSTALL REAR BUMPER SIDE RETAINER LH

a.
B280046

Engage the 6 claws.


b.

Install the rear bumper side retainer LH with the 3 screws.


Hide 52575 5.INSTALL REAR BUMPER SIDE RETAINER RH

HINT:

Use the same procedure as for the LH side.


Hide 89348 6.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

Hide 89341A 7.INSTALL NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

Hide 89348J 8.INSTALL ULTRASONIC SENSOR CLIP (w/ TOYOTA Parking Assist-sensor System)

Hide 9.INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)

a.
B293806

Connect the 2 connectors.


b.

Engage the 2 clamps to install the No. 2 luggage room wire.