Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › SFI SYSTEM › 2011.10–2013.07
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0075838 SFI SYSTEM L

2AR-FE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


INITIALIZATION


NOTICE:
·

If the ECM is replaced, register the ECU communication ID for Engine Immobiliser System (w/o smart entry and start system) (Refer to the Service Bulletin for Registration).

·

Make sure to perform Reset Memory (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (for Automatic Transaxle models) (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

·

When the cable is disconnected from the negative (-) battery terminal, initialize the following system after the cable is reconnected.

System Name See Procedure
Parking Assist Monitor System (Click here)



HINT:

Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.



WHEN USING INTELLIGENT TESTER


CAUTION:

Observe the following items for safety reasons:


·

Before using the tester, read the instruction manual.

·

Prevent the tester cable from being caught on the pedals, shift lever or steering wheel when driving with the tester connected to the vehicle.

·

When driving the vehicle for testing purposes using the tester, 2 persons are required. One is for driving the vehicle, and the other operates the tester.



IGNITION SWITCH EXPRESSIONS


HINT:

The type of ignition switch used on this model differs depending on the specifications of the vehicle.

The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off (Lock)
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START On (Start)