Home › Drivetrain › U760E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM
RM19V0EQ _52 Drivetrain _014582 U760E AUTOMATIC TRANSMISSION / TRANSAXLE _0076198 AUTOMATIC TRANSAXLE SYSTEM D

U760E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  MANUAL SHIFTING TEST  


PERFORM MANUAL SHIFTING TEST


HINT:
·

Using this test, it can be determined whether a problem is in an electrical circuit or if it is a mechanical problem in the transaxle.

·

If any abnormalities are found in the following test, the problem is in the transaxle itself.



a.
C247645

Disconnect the connector of the wiring harness connector.

HINT:

It is possible to deactivate the electrical shift control by disconnecting the harness connector. The gears can then be changed mechanically with the shift lever.



b.

Drive with the harness connector disconnected. Move the shift lever to each position to check whether the gear changes as shown in the table below.

Shift Lever Position Gear
P P
R R
D 3rd
No Shift (Gears will not change)


c.

Connect the connector of the wiring harness connector.


d.

Clear the DTCs (See page Drivetrain>U760E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>DTC CHECK / CLEAR).

Powertrain > Engine and ECT > Clear DTCs
50002 234