Home › Drivetrain › U760E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM
RM19V0EQ _52 Drivetrain _014582 U760E AUTOMATIC TRANSMISSION / TRANSAXLE _0076198 AUTOMATIC TRANSAXLE SYSTEM C

U760E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  U0100  Lost Communication with ECM / PCM "A"  


DESCRIPTION

The engine control unit and the transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control ECU with the Controller Area Network (CAN).

If there is a problem in this intercommunication, the ECM sets a DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
U0100 Lost Communication with ECM / PCM "A"

Following conditions are met for 1.25 seconds (1 trip detection logic):

1.

Ignition switch ON

2.

Battery voltage is 10.5 V or more

3.

No intercommunication between engine control ECU and transmission control ECU



ECM Comes on DTC stored

PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U0100)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Enter the following menus: Powertrain / Engine and ECT / DTC.

Powertrain > Engine and ECT > Trouble Codes
50001 234

d.

Check if DTCs are output.

Result:
Display (DTC Output) Proceed to
U0100 A
U0100 and other DTCs B




A

B