Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2011.10–2016.05
RM19V0EQ _54 Brake _014591 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0076218 ANTI-LOCK BRAKE SYSTEM L

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected:


System See Procedure
Parking Assist Monitor System (Click here)


TROUBLESHOOTING PRECAUTIONS


a.

When there is a malfunction with terminal contact points or part installation problems, removal and installation of the suspected parts may return the system to normal either completely or temporarily.


b.

In order to determine the malfunctioning area, be sure to check the conditions at the time the malfunction occurred, such as DTC output and the Freeze Frame Data, and record it before disconnecting any connector or removing and installing parts.


c.

Since the system may be influenced by malfunctions in systems other than the ABS system, be sure to check for DTCs in other systems.



HANDLING PRECAUTIONS


a.

Be sure to perform preparation before work and confirmation after work is completed by following the directions in the repair manual when working on the ABS system.


b.

Be sure to remove and install the ECU, brake actuator assembly, sensors, etc. with the ignition switch off unless it is otherwise specified in the inspection procedure.


c.

If the ECU, brake actuator assembly or a sensor has been removed and installed, it is necessary to check the system for problems after the parts have been reassembled. Check for DTCs using the intelligent tester, also check that system functions and signals received by the ECU are normal using Test Mode.



DTC PRECAUTION


a.

Warnings for some DTCs cannot be cleared only by repairing the malfunctioning parts. If the warning is displayed after repair work, the DTC should be cleared after turning the ignition switch off.

NOTICE:

If a DTC for a malfunctioning part reappears after it was cleared, then it has been stored again.



b.

When 2 or more DTCs are detected, perform diagnosis for each DTC, one by one until the problem is identified.



CAN COMMUNICATION SYSTEM PRECAUTIONS


a.

The CAN communication system is used for communication between the skid control ECU (brake actuator assembly) and other ECUs. If any CAN communication DTCs are detected, DTCs corresponding to the malfunction will be output.


b.

If any CAN communication DTCs are output, repair the malfunction and troubleshoot the ABS system while communication is normal.


c.

In order to enable CAN communication, a specific type of wiring is used for the CAN communication lines. The wiring used for each communication line is a twisted pair of wires that have an equal length. A bypass wire should not be used because the data being transmitted will be corrupted.