Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2011.10–2016.05
RM19V0EQ _54 Brake _014591 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0076218 ANTI-LOCK BRAKE SYSTEM U

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Warm up the engine.


b.

Turn the ignition switch off.


c.

Connect the intelligent tester to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the intelligent tester on.


f.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.


g.

According to the display on the tester, read the Data List.

Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
ABS Warning Light ABS warning light ON or OFF ON: Warning light on
OFF: Warning light off
-
Brake Warning Light Brake warning light ON or OFF ON: Warning light on
OFF: Warning light off
-
Stop Light SW Stop light switch ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released
-
Parking Brake SW Parking brake switch ON or OFF ON: Parking brake applied
OFF: Parking brake released
-
FR Wheel Speed Front wheel speed sensor RH reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
FL Wheel Speed Front wheel speed sensor LH reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
RR Wheel Speed Rear wheel speed sensor RH reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
RL Wheel Speed Rear wheel speed sensor LH reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
FR Wheel Acceleration Front wheel RH acceleration Min.: -200.84 m/s2, Max.: 199.27 m/s2 - During deceleration/acceleration: Changes continuously
FL Wheel Acceleration Front wheel LH acceleration Min.: -200.84 m/s2, Max.: 199.27 m/s2 - During deceleration/acceleration: Changes continuously
RR Wheel Acceleration Rear wheel RH acceleration Min.: -200.84 m/s2, Max.: 199.27 m/s2 - During deceleration/acceleration: Changes continuously
RL Wheel Acceleration Rear wheel LH acceleration Min.: -200.84 m/s2, Max.: 199.27 m/s2 - During deceleration/acceleration: Changes continuously
FR Wheel ABS Ctrl Status Front wheel RH ABS control status ON or OFF ON: During control -
FL Wheel ABS Ctrl Status Front wheel LH ABS control status ON or OFF ON: During control -
RR Wheel ABS Ctrl Status Rear wheel RH ABS control status ON or OFF ON: During control -
RL Wheel ABS Ctrl Status Rear wheel LH ABS control status ON or OFF ON: During control -
FR Wheel EBD Ctrl Status Front wheel RH EBD control status ON or OFF ON: During control -
FL Wheel EBD Ctrl Status Front wheel LH EBD control status ON or OFF ON: During control -
RR Wheel EBD Ctrl Status Rear wheel RH EBD control status ON or OFF ON: During control -
RL Wheel EBD Ctrl Status Rear wheel LH EBD control status ON or OFF ON: During control -
Solenoid Relay ABS solenoid relay ON or OFF ON: Solenoid relay on
OFF: Solenoid relay off
-
ECB Motor Relay ABS motor relay ON or OFF ON: Motor relay on
OFF: Motor relay off
ECB: Electronically Controlled Brake
ABS Solenoid (SFRH) ABS solenoid (SFRH) ON or OFF ON: Operating -
ABS Solenoid (SFRR) ABS solenoid (SFRR) ON or OFF ON: Operating -
ABS Solenoid (SFLH) ABS solenoid (SFLH) ON or OFF ON: Operating -
ABS Solenoid (SFLR) ABS solenoid (SFLR) ON or OFF ON: Operating -
ABS Solenoid (SRRH) ABS solenoid (SRRH) ON or OFF ON: Operating -
ABS Solenoid (SRRR) ABS solenoid (SRRR) ON or OFF ON: Operating -
ABS Solenoid (SRLH) ABS solenoid (SRLH) ON or OFF ON: Operating -
ABS Solenoid (SRLR) ABS solenoid (SRLR) ON or OFF ON: Operating -
BS1 Voltage Value +BS voltage value Min.: 0.00 V, Max.: 20.00 V - Changes in proportion to battery voltage
MT Voltage Value Motor voltage value Min.: 0.00 V, Max.: 20.00 V - Changes in proportion to battery voltage
Number of DTC Number of DTC recorded Min.: 0, Max.: 255 - -
IG Voltage Value Decreased +BS voltage value decrease detection Error or Normal Error: Voltage low
Normal: Normal
-
IG Voltage Value Increased +BS voltage value increase detection Error or Normal Error: Voltage high
Normal: Normal
-


ACTIVE TEST


HINT:

Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts to operate without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Warm up the engine.


b.

Turn the ignition switch off.


c.

Connect the intelligent tester to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the intelligent tester on.


f.

Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.


g.

According to the display on the tester, perform the Active Test.

Chassis > ABS/VSC/TRC > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
ABS Warning Light ABS warning light Warning light ON/OFF Can be observed on the combination meter assembly
Brake Warning Light Brake warning light Warning light ON/OFF Can be observed on the combination meter assembly
Motor Relay ABS motor relay Relay ON/OFF Operating sound of motor can be heard
ABS Solenoid (SRLR) ABS solenoid (SRLR) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SRLH) ABS solenoid (SRLH) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SRRR) ABS solenoid (SRRR) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SRRH) ABS solenoid (SRRH) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SFLR) ABS solenoid (SFLR) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SFLH) ABS solenoid (SFLH) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SFRR) ABS solenoid (SFRR) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SFRH) ABS solenoid (SFRH) Solenoid ON/OFF Operating sound of solenoid (clicking sound) can be heard