The skid control ECU receives signals from the ECM via the CAN communication system.
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073 | Control Module Communication Bus OFF | The +BS terminal voltage is between 9.6 and 16.5 V and bus off is judged for 0.1 seconds or more. | CAN communication system |
Inspect CAN communication system.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.
| Proceed to |
|---|
| NEXT |
NEXT