Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM19V0EQ _54 Brake _014591 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0076219 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1300  Skid Control ECU Malfunction  


DESCRIPTION

The skid control ECU stores this DTC if malfunctions are found in the circuit inside the ECU by self diagnosis.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1300 Skid Control ECU Malfunction Internal failure of the skid control ECU control unit. Skid control ECU (Brake actuator assembly)

PROCEDURE

1.REPLACE BRAKE ACTUATOR ASSEMBLY
a.

Replace the skid control ECU (brake actuator assembly).

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL

HINT:

This DTC is output when the skid control ECU detects a malfunction in the internal circuit.




c.

Perform the sensor check using the Test Mode procedure.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE

Chassis > ABS/VSC/TRC > Utility
Tester Display
Test Mode
50005 105 166

Result:
Proceed to
NEXT



NEXT

END