The ECM turns on the SET indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.
The cruise control SET indicator light illuminates when the cruise control system is controlling vehicle speed.
The cruise control indicator light circuit uses CAN communication. If the cruise control indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.
Refer to Cruise Main Indicator Light Circuit (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>Cruise Main Indicator Light Circuit).
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
Check the cruise control SET indicator light by performing the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. SET | Cruise control SET indicator light | Cruise control SET indicator light ON / OFF | - |
| Tester Display |
|---|
| Indicat. SET |
The cruise control SET indicator light goes on or off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG