Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2011.10–2015.04
RM19V0EQ _58 Vehicle Interior _014608 METER / GAUGE / DISPLAY _0074143 METER / GAUGE SYSTEM W

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE METER / GAUGE SYSTEM


a.

Customizing with the intelligent tester

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the intelligent tester on.


iv.

Enter the following menus: Customize Setting / Combination Meter / Warning.


v.

Select the setting by referring to the table below.

NOTICE:

Be sure to record the current value before customizing.



Warning
Tester Display Description Default Setting ECU
Key Remind Sound Function to change the cycle of the key remind warning buzzer Slow 00:Normal,01:Slow,10:Fast Combination meter assembly
Driver Side Seatbelt Warning Buzzer Function to turn on/off the seat belt warning buzzer*1 ON 0:OFF,1:ON Combination meter assembly
Front Passenger Side Seatbelt Warning Buzzer Function to turn on/off the seat belt warning buzzer*1 ON 0:OFF,1:ON Combination meter assembly
Rear Seatbelt Warning Buzzer Function to turn on/off the seat belt warning buzzer*2 ON 0:OFF,1:ON Combination meter assembly
50006 7

*1: This setting is only valid for the buzzer which sounds at 20 km/h (12 mph) or more

*2: for RHD




b.

Customizing with the combination meter assembly

HINT:
·

Press and hold the ODO/TRIP change switch to enter the mode.

·

Briefly press the ODO/TRIP change switch to select an item.



i.

Turn the ignition switch to ON.


ii.

Select the setting by referring to the table below.

NOTICE:

Be sure to record the current value before customizing.



Combination meter assembly display Default Content Setting Relevant ECU
ECO INDICATOR ON Function to display/not display the eco indicator and current fuel economy display ON or OFF Combination meter assembly


iii.

Press and hold the ODO/TRIP change switch.


iv.

Return to the item selection screen.