Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM
RM19V0EQ _59 Vehicle Exterior _014621 LIGHTING (EXT) _0074247 AUTOMATIC HIGH BEAM SYSTEM W

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE AUTOMATIC HIGH BEAM SYSTEM


HINT:

The following item can be customized.


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



a.

Customizing with the intelligent tester

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the intelligent tester on.


iv.

Enter the following menus: Customize Setting / Light Control.


v.

Select the setting by referring to the table below.

Light Control
Tester Display Description Default Setting ECU
Automatic High Beam Enabling (ON) or disabling (OFF) of the automatic high beam function ON 0:OFF,1:ON Main Body ECU (Multiplex Network Body ECU)
50006 8