GENERAL
This system uses ultrasonic sensors to detect obstacles at the rear of the vehicle. If an obstacle is detected, the system then informs the driver of the distance between the sensor and obstacle by sounding a buzzer.
FUNCTION OF COMPONENTS
| Component | Function |
|---|---|
| No. 1 Ultrasonic Sensor (2) | Detects the distance between the vehicle and an obstacle |
| No. 1 Clearance Warning Buzzer | Sounds to inform the driver according to the distance to an obstacle |
| Back Sonar or Clearance Sonar Switch Assembly | Operating this switch enables, disables or cuts off the operation of the Toyota parking assist-sensor system |
| Clearance Warning ECU Assembly | Judges the approximate distance between the vehicle and an obstacle based on the signals from the ultrasonic sensors and sounds the buzzer. |
| Park/Neutral Position Switch Assembly | Transmits a shift position signal to the clearance warning ECU assembly |
OPERATION EXPLANATION
The operating conditions of the ultrasonic sensors are as follows.
| Installation Position | Operating Condition |
|---|---|
| Rear Center Sensor | ·
Ignition switch is ON. ·
Clearance sonar main switch is on. ·
Shift lever is in R. |
When the system operates, the clearance warning ECU assembly transmits ultrasonic waves from the ultrasonic sensors. If these waves encounter an obstacle within one or more of the sensors ranges, the waves are reflected back to the sensors, which transmit them to the clearance warning ECU assembly.
Based on this information, the clearance warning ECU assembly sends signals to the clearance warning buzzer. The approximate distance between the vehicle and the obstacle is then indicated, and the buzzer sounds.
Refer to Detection Range Measurement Inspection.
COMMUNICATION SIGNALS OF COMPONENTS
Allocation refers to the process of the clearance warning ECU assembly setting aside IDs for the sensors.
The vehicle has the sensors arranged in 1 group. There is a rear series. The sensors are connected in a "daisy chain".
Initialization mode:
An ID is allocated to each sensor and sensor diagnosis is performed.
When the initial check is operating (the ignition switch is ON and the clearance sonar main switch is on), the clearance warning ECU assembly provides power to the first sensors in the series (rear right center sensor).
After the power is supplied, the rear right center sensor enters standby mode to receive an ID from the ECU. When a certain amount of time has elapsed, the ECU sends an ID allocation signal to these sensors.
The rear right center sensor receives the ID allocation signal from the ECU and performs self-diagnosis. When the sensor self-diagnosis is complete, the ECU sends an ID allocation confirmation signal to the sensor.
After the ID allocation confirmation is performed, the ECU provides power to the second sensor in the series (rear left center sensor) via the first sensor. In the same manner as the first sensor, the second sensor enters standby mode. When a certain amount of time has elapsed, the ECU sends an ID allocation signal to the second sensor. Initialization ends when ID allocation to both ultrasonic sensors is complete.
Detection mode:
After initialization mode is completed, the system switches into detection mode. In detection mode, the clearance warning ECU assembly sends information request signals and sensor activation signals to the ultrasonic sensors and receives detection result signals from the sensors.
The ECU regularly sends ID signals, information request signals, and sensor activation signals to each ultrasonic sensor according to the communication schedule.
When a certain amount of time has elapsed (sensor detection operation is completed), the ECU sends an ID signal to the sensor to receive a detection result signal.
The ultrasonic sensor sends a detection result signal or detection information signal to the ECU.
The above operation is performed repeatedly for each ultrasonic sensor.