Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 2 Sensor Type) › 2011.10–2016.05
RM19V0EQ _56 Audio / Visual / Telematics _014601 PARK ASSIST / MONITORING _0076583 TOYOTA PARKING ASSIST-SENSOR SYSTEM U

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  TERMINALS OF ECU  


CLEARANCE WARNING ECU ASSEMBLY


E220917
3.5,0.104 3.896,0.344 0.396,0.24 3.604,0.135 3.833,0.313 0.229,0.177 10 I82

a.

Disconnect the I82 clearance warning ECU assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
I82-1 (IG) - I82-30 (E) B - BR Back sonar or clearance sonar switch assembly power source signal Ignition switch ON, clearance sonar main switch on 11 to 14 V
I82-1 (IG) - I82-30 (E) B - BR Back sonar or clearance sonar switch assembly power source signal Ignition switch ON, clearance sonar main switch off Below 1 V
I82-27 (RL) - I82-30 (E) SB - BR R shift position signal Ignition switch ON, shift lever in any position except R Below 1 V
Ignition switch ON, shift lever in R 11 to 14 V
I82-30 (E) - Body ground BR - Body ground Ground Always Below 1 Ω


c.

Reconnect the I82 clearance warning ECU assembly connector.


d.

Measure the voltage and check for pulses according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
I82-22 (BOR) - I82-30 (E) V - BR Power source for rear sensor circuit Ignition switch off Below 1 V
Ignition switch ON, clearance sonar main switch on 7.2 to 8.8 V
I82-13 (ER) - I82-30 (E) R - BR Clearance warning buzzer signal Buzzer sounding Pulse generation
(See waveform 1)
I82-23 (E1) - I82-30 (E) GR - BR Ground for rear clearance sonar Always Below 1 V
I82-24 (SOR) - I82-30 (E) R - BR Rear sensor communication signal (Rear clearance sonar sensor) Ignition switch ON, clearance sonar main switch on, shift lever in R Pulse generation
(See waveform 2)


e.

Using an oscilloscope, check waveform 1.

i.
E227014
0.073,1.688 0.542,1.948 0.469,0.26 10 GND

Waveform 1 (Reference)

Item Content
Terminal No. (Symbol) I82-13 (ER) - I82-30 (E)
Tool Setting 2 V/DIV., 500 μsec./DIV.
Vehicle Condition When sonar detects obstacle (buzzer sounds)



f.

Using an oscilloscope, check waveform 2.

i.
E235241
0.156,0.938 0.594,1.177 0.438,0.24 10 GND

Waveform 2 (Reference)

Item Content
Terminal No. (Symbol) I82-24 (SOR) - I82-30 (E)
Tool Setting 5 V/DIV., 1 msec./DIV.
Condition Ignition switch ON, clearance sonar main switch on, shift lever in R