51100G
1.REMOVE FRONT FRAME ASSEMBLY
48829A
2.REMOVE FRONT NO. 1 STABILIZER BRACKET LH
48824A
3.REMOVE FRONT NO. 1 STABILIZER BRACKET RH
Perform the same procedure as the LH side.
4.REMOVE FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY
Remove the front stabilizer bar with 2 front stabilizer link assemblies from the front frame assembly.
5.REMOVE STEERING LINK ASSEMBLY
48069
6.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly from the front frame assembly.
When removing the bolt, keep the nut from rotating.
Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly.
48068
7.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Perform the same procedure as the LH side.
51227B
8.REMOVE FRONT SUSPENSION MEMBER DYNAMIC DAMPER
Remove the 2 bolts and front suspension member dynamic damper from the front frame assembly.
52213A
9.REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING FRONT STOPPER
Remove the 2 front suspension member body mounting front stoppers from the front frame assembly.
52216B
10.REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING REAR STOPPER
Remove the 2 front suspension member body mounting rear stoppers from the front frame assembly.
52211J
11.REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING FRONT CUSHION
| *1 | Front Suspension Member Body Mounting Front Cushion |
Install SST as shown in the illustration.
| *a | Turn |
| *b | Hold |
Using SST, remove the front suspension member body mounting front cushion from the front frame assembly.
Make sure that the claws of SST are securely hung onto the mounting cushion.
Tighten SST slowly and evenly.
Be careful as the mounting cushion may fly out.
The mounting cushion cannot be reused.
52217E
12.REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION LH
| *1 | Front Suspension Member Body Mounting Rear Cushion LH |
Install SST as shown in the illustration.
| *a | Turn |
| *b | Hold |
Using SST, remove the front suspension member body mounting rear cushion LH from the front frame assembly.
Make sure that the claws of SST are securely hung onto the mounting cushion.
Tighten SST slowly and evenly.
Be careful as the mounting cushion may fly out.
The mounting cushion cannot be reused.
52215
13.REMOVE FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION RH
Perform the same procedure as the LH side.
14.REMOVE HOLE PLUG
Remove 9 hole plugs from the front frame assembly.