84986
1.INSPECT VEHICLE STABILITY CONTROL SWITCH
| *a | Component without harness connected
(Vehicle Stability Control Switch) |
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the vehicle stability control switch connector.
Check both the connector case and the terminal for deformation and corrosion.
No deformation or corrosion.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 9 (+) - 6 (E) | Switch pushed | Below 1 Ω |
| 9 (+) - 6 (E) | Switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the vehicle stability control switch.