Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEEL
2.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
47313A
3.SEPARATE FRONT FLEXIBLE HOSE
Remove the union bolt and 2 gaskets, and separate the front flexible hose from the disc brake cylinder assembly.
47750
4.REMOVE DISC BRAKE CYLINDER ASSEMBLY
| *a | Hold |
| *b | Turn |
Hold the front disc brake cylinder slide pin, and remove the 2 bolts and disc brake cylinder assembly.
5.REMOVE FRONT DISC BRAKE PAD
Remove the 2 front disc brake pads from the front disc brake cylinder mounting.
47716
6.REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
Remove the 2 front disc brake pad support plates from the front disc brake cylinder mounting.
47715A
7.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN
Remove the 2 front disc brake cylinder slide pins with the front disc brake bushing dust boot from each front disc brake cylinder mounting.
47775
8.REMOVE FRONT DISC BRAKE BUSHING DUST BOOT
Remove the front disc brake bushing dust boot from the front disc brake cylinder slide pin.
47722
9.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING
Remove the 2 bolts and front disc brake cylinder mounting from the steering knuckle.
43512
10.REMOVE FRONT DISC
| *a | Matchmark |
Put matchmarks on the front disc and the front axle hub.
Remove the front disc.