Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
43512
1.INSTALL FRONT DISC
| *a | Matchmark |
Align the matchmarks of the front disc and front axle hub, and install the front disc.
When replacing the front disc with a new one, select the installation position where the front disc has minimal runout.
47722
2.INSTALL FRONT DISC BRAKE CYLINDER MOUNTING
Install the front disc brake cylinder mounting to the steering knuckle with the 2 bolts.
47775
3.INSTALL FRONT DISC BRAKE BUSHING DUST BOOT
|
Lithium Soap Base Glycol Grease |
Apply a light layer of lithium soap base glycol grease to the seal surface of 2 new front disc brake bushing dust boots.
Apply at least 0.3 g (0.01 oz) of lithium soap base glycol grease to each front disc brake bushing dust boot.
Apply a light layer of lithium soap base glycol grease to the sliding part and the seal surface of the front disc brake cylinder slide pin.
Install the 2 front disc brake bushing dust boots to each front disc brake cylinder slide pin.
47715A
4.INSTALL FRONT DISC BRAKE CYLINDER SLIDE PIN
Install the 2 front disc brake cylinder slide pins to the front disc brake cylinder mounting.
Install the front disc brake bushing dust boot to the groove of the front disc brake cylinder mounting.
47716
5.INSTALL FRONT DISC BRAKE PAD SUPPORT PLATE
Install the front disc brake pad support plate.
04465
6.INSTALL FRONT DISC BRAKE PAD
| *A | Outer Side |
| *B | Inner Side |
| *1 | Pad Wear Indicator |
Install the 2 front brake pads to the front disc brake cylinder mounting.
There should be no oil or grease on the friction surfaces of the front disc brake pads or the front disc.
47750
7.INSTALL DISC BRAKE CYLINDER ASSEMBLY
| *a | Hold |
| *b | Turn |
Hold the front disc brake cylinder slide pin, and install the front disc brake cylinder assembly to the front disc brake cylinder mounting with 2 new bolts.
47313A
8.CONNECT FRONT FLEXIBLE HOSE
| *a | Lock Hole |
Connect the front flexible hose to the front disc brake cylinder assembly with a new union bolt and 2 new gaskets.
Install the flexible hose lock securely into the lock hole in the front disc brake cylinder.
9.BLEED BRAKE LINE
10.INSTALL FRONT WHEEL