Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE › from 2015.04
RM19V0EQ _54 Brake _014593 BRAKE (FRONT) _0074049 FRONT BRAKE FLEXIBLE HOSE A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.

·

If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.



HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 47313A 1.INSTALL FRONT FLEXIBLE HOSE

a.
C238495C07
2.023,0.979 2.175,1.122 0.152,0.143 10 *1 1.845,1.054 2.009,1.054 false
*1 Clip


Install a new clip to the front flexible hose.

NOTICE:

Install the clip as far as it will go.



b.

Using a union nut wrench, connect the brake line to the front flexible hose while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

·

Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




c.
C239561C02
1.135,0.802 0.469,0.344 0.469,0.344 1.198,0.677 true 1.156,0.917 1.021,1.042 1.021,1.042 0.781,1.042 true 1.479,0.406 1.563,0.24 1.563,0.24 1.688,0.24 true 1.708,0.146 1.938,0.479 0.229,0.333 10 *1 0.615,0.969 0.906,1.24 0.292,0.271 10 *2 0.281,0.229 0.583,0.604 0.302,0.375 10 *3
*1 Front Speed Sensor Clamp
*2 Front Flexible Hose
*3 Claw


Install the front speed sensor clamp and front flexible hose to the shock absorber bracket with the bolt.

Torque:
19 N*m (192 kgf*cm, 14 ft.*lbf)

NOTICE:
·

Do not twist the wire harness for the front speed sensor when installing it.

·

Securely set the 2 claws of the front speed sensor clamp to the shock absorber bracket.

·

A bolt tightens the brake flexible hose and front speed sensor together. Make sure that the front flexible hose is positioned over the front speed sensor.




d.
C246328C01
2.947,0.953 3.114,1.1 0.166,0.147 10 *a 1.561,1.033 2.91,1.033 false
*a Lock Hole


Connect the front flexible hose to the front disc brake cylinder assembly with a new union bolt and 2 new gaskets.

Torque:
30 N*m (305 kgf*cm, 22 ft.*lbf)

NOTICE:

Install the flexible hose lock securely into the lock hole in the front disc brake cylinder.



Hide 3.INSTALL FRONT WHEEL

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)