47731B
1.REMOVE REAR DISC BRAKE PISTON
Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder assembly.
Apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder assembly.
Do not place your fingers in front of the rear disc brake piston when using compressed air.
Do not allow any brake fluid to spatter.
2.REMOVE CYLINDER BOOT
Remove the cylinder boot from the rear disc brake cylinder assembly.
3.REMOVE PISTON SEAL
| *1 | Vinyl Tape |
Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the rear disc brake cylinder.
Do not damage the inner surface or piston seal groove of the disc brake cylinder.
31478C
4.REMOVE REAR DISC BRAKE BLEEDER PLUG CAP
47547C
5.REMOVE REAR DISC BRAKE BLEEDER PLUG