Home › Brake › BRAKE (REAR) › REAR BRAKE › from 2015.04
RM19V0EQ _54 Brake _014594 BRAKE (REAR) _0074050 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  REASSEMBLY  


PROCEDURE

Hide 47547C 1.TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG

HINT:

Fully tighten the rear disc brake bleeder plug after bleeding the system.


Hide 31478C 2.INSTALL REAR DISC BRAKE BLEEDER PLUG CAP

Hide 3.INSTALL PISTON SEAL

a.

Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.


b.

Install the piston seal to the rear disc brake cylinder.

NOTICE:

Securely install the piston seal to the groove of the rear disc brake cylinder.



Hide 4.INSTALL CYLINDER BOOT

a.
C239545C03
2.511,0.401 2.667,0.557 0.156,0.156 10 *1 2.516,1.352 2.679,1.508 0.163,0.156 10 *2 2.191,0.477 2.48,0.477 false 2.077,1.44 2.48,1.44 false
*1 Cylinder Boot
*2 Rear Disc Brake Piston
V100155

Lithium Soap Base Glycol Grease


Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot and rear disc brake piston.


b.
C248019

Install the cylinder boot to the rear disc brake piston.


Hide 47731B 5.INSTALL REAR DISC BRAKE PISTON

a.
C145785C01
1.306,2.998 1.464,3.149 0.158,0.151 10 *1 0.969,2.657 1.134,2.812 0.165,0.155 10 *2 0.725,2.733 0.963,2.733 false 1.028,3.234 1.172,3.09 1.172,3.09 1.305,3.09 false
*1 Cylinder Boot
*2 Rear Disc Brake Piston


Install the cylinder boot securely to the grooves of the rear disc brake cylinder.

NOTICE:
·

Securely install the cylinder boot into the groove of the disc brake cylinder and rear disc brake piston.

·

Do not damage the cylinder boot.




b.

Push in the piston by hand and install the boot onto the grooves of the piston.