CHECK DLC3
Check the DLC3.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION
FUNCTION OF WARNING INDICATOR AND MESSAGE
If the pre-crash safety system is not functioning properly, the driver is warned by the PCS warning indicator and a warning message on the multi-information display in the combination meter assembly.
Initial check
The initial check occurs when the engine switch is off for more than 2 seconds, and then turned on (IG). The initial check consists of a pre-crash safety system diagnostic check with a duration of approximately 3 seconds.
If a malfunction is detected during the initial check, the multi-information display will display "Check Pre-Crash Safety" or "Pre-Crash Safety Temporarily Not Available".
Constant check
The driving support ECU assembly constantly monitors the pre-crash safety system for malfunctions after the engine switch is turned on (IG) and the initial check (approximately 3 seconds) has completed.
"Check Pre-Crash Safety" or "Pre-Crash Safety Temporarily Not Available" is displayed on the multi-information display in the combination meter assembly when the constant check detects malfunctions in the pre-crash safety system.