When a new driving support ECU assembly is installed, it receives vehicle specification information (destination, steering wheel position, etc.) from the main body ECU (multiplex network body ECU) and memorizes the information.
DTC C1A02 is stored when the driving support ECU assembly receives the vehicle specification information from the main body ECU (multiplex network body ECU) but cannot record it.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A02 | Vehicle Information Not Obtained | Inconsistent vehicle specification information between the main body ECU (multiplex network body ECU) and driving support ECU assembly continues for 0.096 second or more while the vehicle is being driven at a speed of 50 km/h (31 mph) or more. | ·
Main body ECU (Multiplex network body ECU) ·
Driving support ECU assembly |
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.
When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Pre-Crash 2 / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Country# (DSS) | Destination country for driving support ECU assembly | JPN, NA, EURO, CA, AUS, SAFC, OTHER, TWN, CHINA, THAI, GCC or NOFIX | Actual country code | - |
| Tester Display |
|---|
| Country# (DSS) |
The country specification information stored in the driving support ECU assembly is determined by the country specification information stored in the main body ECU (multiplex network body ECU). If the country specification information for the millimeter wave radar sensor assembly matches the vehicle, the country specification information for the main body ECU (multiplex network body ECU) and driving support ECU assembly is incorrect and the main body ECU (multiplex network body ECU) and driving support ECU assembly need to be replaced.
| Result | Proceed to |
|---|---|
| Country specification information for vehicle and driving support ECU assembly match | A |
| Country specification information for vehicle and driving support ECU assembly do not match | B |
A
B
Main body ECU: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>COMPONENTS
Driving support ECU assembly: Click hereEngine / Hybrid System>CRUISE CONTROL>DRIVING SUPPORT ECU>COMPONENTS
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs.
Click hereVehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
Click hereVehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC C1A02 is not output | A |
| DTC C1A02 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B