Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2015.04
RM19V0EQ _58 Vehicle Interior _034909 PRE-CRASH SAFETY _0163370 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  C1A46  Yaw Rate Sensor  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives the airbag sensor assembly (yaw rate sensor) and sends the signals to the driving support ECU assembly. If the skid control ECU (brake actuator assembly) detects that the airbag sensor assembly (yaw rate sensor) is malfunctioning, the skid control ECU (brake actuator assembly) sends a malfunction signal to the driving support ECU assembly, and the driving support ECU assembly stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A46 Yaw Rate Sensor While the vehicle speed is 5 km/h (3 mph) or more, an airbag sensor assembly (yaw rate sensor) malfunction signal is received from the skid control ECU (brake actuator assembly) for 9.632 seconds or more.
·

Vehicle stability control system

·

Skid control ECU (brake actuator assembly)

·

Driving support ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.


PROCEDURE

1.CHECK FOR DTCS (ABS/VSC/TRC)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.


e.

Check for DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Result Proceed to
Vehicle stability control system DTCs are not output A
Vehicle stability control system DTCs are output B




A

2.REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)

B

2.REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)
a.

Replace the skid control ECU (brake actuator assembly) with a new one.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTCS (PRE-CRASH 2)
3.CHECK FOR DTCS (PRE-CRASH 2)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Clear the DTCs.

Click hereVehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR

Body Electrical > Pre-Crash 2 > Clear DTCs
50002 220

e.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



f.

Check for DTCs.

Click hereVehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR

Body Electrical > Pre-Crash 2 > Trouble Codes
50001 220
Result:
Result Proceed to
DTC C1A46 is not output A
DTC C1A46 is output B




A

END (SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) WAS DEFECTIVE)

B

REPLACE DRIVING SUPPORT ECU ASSEMBLY