INPUT SIGNAL CHECK
| *a | ON-OFF |
| *b | -/SET |
| *c | +/RES |
Connect the GTS to the DLC3.
Check the cruise control switch using the Data List function of the GTS (ON-OFF, -/SET and +/RES).
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Main SW M-CPU | Cruise control main switch signal (Main CPU) | ON or OFF | ON: Cruise control main switch on
OFF: Cruise control main switch off |
- |
| SET/COAST Switch | -/SET switch signal | ON or OFF | ON: -/SET switch on
OFF: -/SET switch off |
- |
| RES/ACC Switch | +/RES switch signal | ON or OFF | ON: +/RES switch on
OFF: +/RES switch off |
- |
| Tester Display |
|---|
| Main SW M-CPU |
| SET/COAST Switch |
| RES/ACC Switch |
INSPECT MODE SWITCH
| *a | ON-OFF |
| *b | MODE |
Turn the engine switch on (IG).
Turn the cruise control system on using the cruise control switch (ON-OFF button). Then push the cruise control switch to MODE for 1 second or more to change to the constant speed control mode.
| *a | Cruise Control Indicator
(Vehicle-to-vehicle distance control mode) |
| *b | Cruise Control Indicator
(Constant speed control mode) |
Check that the cruise control indicator (vehicle-to-vehicle distance control mode) goes off and the cruise control indicator (constant speed control mode) illuminates.
Do not push any other switches before pushing the cruise control main switch to MODE. If another switch is pushed, turn the dynamic radar cruise control system off and repeat the procedure.
If a malfunction is detected, turn the engine switch off and repeat the procedure above.
INSPECT STEERING PAD SWITCH ASSEMBLY
Turn the engine switch on (IG).
Turn the cruise control system on using the cruise control main switch.
Press the steering pad switch assembly (distance control switch).
| *a | Distance Control Switch (Vehicle-to-vehicle Distance Control) | - | - |
Check that the indication of the vehicle-to-vehicle distance, which is shown on the multi-information display in the combination meter assembly, changes from long to middle to short in that order.
| *a | Long | *b | Middle |
| *c | Short | - | - |
Long is automatically selected each time the engine is started.