This circuit provides power to operate the lane departure warning camera.
Inspect the fuses for circuits related to this system before performing the following procedure.
| *a | Front view of wire harness connector
(to Lane Departure Warning Camera) |
Disconnect the S14 lane departure warning camera connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S14-7 (IGB) - Body ground | Engine switch on (IG) | 11 to 14 V |
| S14-7 (IGB) - Body ground | Engine switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S14-11 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG