The lane departure warning camera receives a lane-keeping assist main switch signal from the lane keeping assist main switch.
Remove the lane-keeping assist main switch.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SWITCH>REMOVAL
Inspect the lane-keeping assist main switch.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the S14 lane departure warning camera connector.
Disconnect the I186 lane-keeping assist main switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S14-4 (LKSW) - I186-6 (ECU) | Always | Below 1 Ω |
| I186-3 (GND) - Body ground | Always | Below 1 Ω |
| S14-4 (LKSW) or I186-6 (ECU) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG