The dynamic radar cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system. If DTC P0500 is detected, perform the diagnosis using the inspection procedure for DTC P0500 in the SFI system.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>P0500
The speed signal is converted for use by the ECM. Both the SFI system and the dynamic radar cruise control system can set DTC P0500, however, the detection conditions of these systems are different.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P0500 | Vehicle Speed Sensor Malfunction | The vehicle speed signal from the vehicle speed sensor is lost for approximately 0.14 seconds or more while the dynamic radar cruise control is operating. | ·
Vehicle speed sensors ·
Vehicle speed sensor signal circuit ·
ECM ·
Combination meter assembly |
Refer to SFI System.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>P0500
This DTC may be output by the SFI system at the same time. In that case, perform troubleshooting for the SFI system first.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
With the shift lever in D, drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).
Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC P0500 is output | B |
Turn the engine switch off.
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B