Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.04
RM19V0EQ _51 Engine / Hybrid System _014581 CRUISE CONTROL _0163371 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P0503  Vehicle Speed Sensor "A" Intermittent / Erratic / High  


DESCRIPTION

If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU (brake actuator assembly) is detected while the dynamic radar cruise control is operating, the ECM determines that there is a momentary interruption or noise, and stores a DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
P0503 Vehicle Speed Sensor "A" Intermittent / Erratic / High A momentary interruption or noise is detected when a rapid change in the vehicle speed occurs while the dynamic radar cruise control system is operating.
·

ECM

·

Combination meter assembly

·

Vehicle speed sensors

·

Vehicle speed sensor signal circuit



CAUTION / NOTICE / HINT

HINT:

This DTC may be set by the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.


PROCEDURE

1.CHECK FOR DTCS (ABS/VSC/TRC)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.


e.

Check for DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output A
DTCs are output B


f.

Turn the engine switch off.



A

2.REPLACE COMBINATION METER ASSEMBLY

B

2.REPLACE COMBINATION METER ASSEMBLY
a.

Replace the combination meter assembly.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTCS (DTC P0503)
3.CHECK FOR DTCS (DTC P0503)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Radar Cruise > Clear DTCs
50002 239

d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which dynamic radar cruise control system operation is possible.


ii.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).


iii.

Push the cruise control main switch to -SET to activate the dynamic radar cruise control system.



e.

Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.


f.

Check for DTCs.

Powertrain > Radar Cruise > Trouble Codes
50001 239

Result:
Result Proceed to
DTCs are not output A
DTC P0503 is output B


g.

Turn the engine switch off.



A

END

B