Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.04
RM19V0EQ _51 Engine / Hybrid System _014581 CRUISE CONTROL _0163371 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P0575  Cruise Control Input Circuit  


DESCRIPTION

This DTC indicates a malfunction in the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area
P0575 Cruise Control Input Circuit ECM has a supervisory CPU and control ECU inside. When each input STP signal is different for approximately 0.15 seconds or more, this DTC is stored. This DTC is also stored after 0.4 seconds have passed from the time a cruise cancel input signal (STP input) is input to the ECM. ECM

CAUTION / NOTICE / HINT

HINT:

The ECM receives signals from each sensor to control all the functions of the dynamic radar cruise control system with its supervisory CPU and control ECU. When a malfunction is detected, the fail-safe remains on until the engine switch is turned off.


PROCEDURE

1.CHECK FOR DTCS (DTC P0575)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Radar Cruise > Clear DTCs
50002 239

d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed of 50 km/h (31 mph) or more.


ii.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).


iii.

Push the cruise control main switch to -SET to activate the dynamic radar cruise control system.



e.

Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.


f.

Check for DTCs.

Powertrain > Radar Cruise > Trouble Codes
50001 239

g.

Turn the engine switch off.


Result:
Result Proceed to
DTCs are not output A
DTC P0575 is output B



A

B