Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR › from 2015.04
RM19V0EQ _59 Vehicle Exterior _014620 WIPER / WASHER _0074240 FRONT WIPER MOTOR A

WIPER / WASHER  FRONT WIPER MOTOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

a.
E226228

Remove the nut and front wiper arm and blade assembly LH.


Hide 2.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

a.
E226229

Remove the nut and front wiper arm and blade assembly RH.


Hide 53867H 3.REMOVE FRONT FENDER TO COWL SIDE SEAL LH

a.
E312134

Disengage the 2 clips and guide, and remove the front fender to cowl side seal LH as shown in the illustration.


Hide 53866J 4.REMOVE FRONT FENDER TO COWL SIDE SEAL RH

HINT:

Use the same procedure as for the LH side.


Hide 55781E 5.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

a.

Disengage the 6 claws and guide as shown in the illustration.

E226232


b.

Disengage the 8 guides and pull out the cowl top ventilator louver sub-assembly as shown in the illustration.

E226234


Hide 6.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for LHD)

a.

Operate the wiper and stop the windshield wiper motor at the automatic stop position.


b.
E226236C05
2.551,2.622 1.815,2.769 false 1.644,2.69 1.841,2.865 0.197,0.175 10 *1
*1 Motor Grommet


Disconnect the connector.


c.

Remove the 2 bolts.


d.

Disengage the motor grommet and remove the windshield wiper motor and link assembly as shown in the illustration.

NOTICE:

Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.



Hide 7.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD)

a.

Operate the wiper and stop the windshield wiper motor at the automatic stop position.


b.
E227522C03
2.545,2.696 1.836,2.811 false 1.673,2.729 1.828,2.878 0.154,0.149 10 *1
*1 Motor Grommet


Disengage the 2 clamps and then disconnect the connector.


c.

Remove the 2 bolts.


d.

Disengage the motor grommet and remove the windshield wiper motor and link assembly as shown in the illustration.

NOTICE:

Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.



Hide 85110 8.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

a.
E226238C05
1.461,1.102 0.923,1.102 false 0.75,1.017 0.91,1.195 0.16,0.178 10 *1
*1 Protective Tape


Using a screwdriver, separate the No. 1 rod from the windshield wiper motor assembly as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



b.
E226240

Using a T30 "TORX" socket wrench, remove the 2 bolts and windshield wiper motor assembly from the wiper link assembly.