Use the same procedure for the RH side and the LH side.
The procedures listed below are for the LH side.
1.REMOVE REAR WHEEL
2.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
42491
3.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
42431
4.REMOVE REAR DISC
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
5.REMOVE PARKING BRAKE SHOE ASSEMBLY
Remove the parking brake shoe assembly as shown in the illustration.
46430
6.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
7.REMOVE NUT AND SCREW ADJUSTING ASSEMBLY
Remove the nut and screw adjusting assembly, parking brake tappet and parking brake push rod.
8.REMOVE ADJUSTMENT PAWL
Remove the adjustment pawl.
9.REMOVE PARKING BRAKE SHOE HOLD PLATE
Remove the parking brake shoe hold bolt and the parking brake shoe hold plate.
89516D
10.DISCONNECT SKID CONTROL SENSOR WIRE
42450B
11.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
12.SEPARATE DUST PLATE
Separate the dust plate from the parking brake plate sub-assembly.
13.REMOVE PARKING BRAKE PLATE SUB-ASSEMBLY
Remove the parking brake plate sub-assembly.
14.REMOVE DUST COVER
Put a 4 mm (0.157 in.) drill bit into a drill.
Tape the 4 mm (0.157 in.) drill bit with the portion of 5 mm (0.197 in.) from the tip uncovered.
5 mm (0.197 in.)
Tape the 4 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.
Lightly press the drill against the rivets, drill off the flanges of the rivets, and remove the 2 rivets.
Cover the dust cover with a piece of cloth to prevent rivet fragments and shavings from scattering.
Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.
Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.
Be careful as the cut rivet will be very hot.
Remove the boot retainer and the dust cover.
Even if the flange is taken off, continue to drill the rivet and push out the remaining fragment using a drill.
Using a vacuum cleaner, remove the rivet fragments and shavings.
15.REMOVE PARKING BRAKE SHOE LEVER
Remove the parking brake shoe lever.