Home › Vehicle Interior › DOOR LOCK › TRANSMITTER BATTERY(w/o Smart Entry and Start System) › from 2015.04
RM19V0EQ _58 Vehicle Interior _014605 DOOR LOCK _0074110 TRANSMITTER BATTERY(w/o Smart Entry and Start System) A

DOOR LOCK  TRANSMITTER BATTERY(w/o Smart Entry and Start System)  REPLACEMENT  


PROCEDURE

Hide 89751A 1.REMOVE TRANSMITTER HOUSING COVER

NOTICE:

Take extra care when handling these precision electronic components.


a.
B386453C01
0.552,0.813 0.896,1.24 false 0.354,0.698 0.667,0.854 0.313,0.156 10 false *a
*a Protective Tape


Insert a precision screwdriver into the gap, and turn the screwdriver to remove the transmitter housing cover.

HINT:

Tape the screwdriver tip before use.



Hide 89758 2.REMOVE DOOR CONTROL TRANSMITTER PACKING

a.
B386454C01
1.292,0.635 1.656,0.292 false 1.667,0.146 1.979,0.302 0.313,0.156 10 false *a
*a Protective Tape


Insert a precision screwdriver into the door control transmitter packing and turn the screwdriver to remove the door control transmitter packing.

HINT:

Tape the screwdriver tip before use.



Hide 89745A 3.REMOVE TRANSMITTER BATTERY

a.
B386455C01
0.958,1.573 0.854,0.854 false 0.885,1.615 1.198,1.802 0.313,0.188 10 false *a
*a Protective Tape


Insert a precision screwdriver into the gap and gently remove the transmitter battery.

NOTICE:
·

Do not push the terminals with your finger.

·

Do not forcibly pry up the transmitter battery as the terminals may be damaged.

·

Do not touch the transmitter battery with wet hands. Moisture may cause rust.

·

Do not touch or move any components inside the transmitter. It may interfere with proper operation.

·

When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.



HINT:

Tape the screwdriver tip before use.



Hide 89745A 4.INSTALL TRANSMITTER BATTERY

a.
B386456

Install a new transmitter battery (lithium battery: CR1620) with the positive (+) side facing upward, as shown in the illustration.

NOTICE:
·

Do not bend the transmitter battery electrode during installation.

·

Keep the inside of the transmitter housing cover free of dust and oil.

·

When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.




Hide 89758 5.INSTALL DOOR CONTROL TRANSMITTER PACKING

a.
B386457

Install the door control transmitter packing as shown in the illustration.


Hide 89751A 6.INSTALL TRANSMITTER HOUSING COVER

a.
B386458

Install the transmitter housing cover as shown in the illustration.


b.

Press one of the transmitter switches and check that the LED illuminates.

OK:

Transmitter LED illuminates when a switch is pressed.