Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for SD) › from 2014.05
RM19V0EQ _56 Audio / Visual / Telematics _014600 NAVIGATION / MULTI INFO DISPLAY _0164321 NAVIGATION SYSTEM(for SD) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for SD)  Cursor or Map Rotates when Vehicle Stopped  


PROCEDURE

1.CHECK CONDITION
a.
E106418

Check with the customer if the vehicle has been turned by a turntable.

OK:

Vehicle has not been turned by a turntable.


HINT:

If the vehicle is turned on a turntable with the ignition switch turned to ACC or to ON, the system may store the angular velocity. As a result, the vehicle position cursor may deviate. In this case, the vehicle position cursor will return to normal by turning the ignition switch off and back to ACC or to ON again with the vehicle completely stopped.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

TURN THE IGNITION SWITCH TO ACC OR TO ON WHEN VEHICLE IS COMPLETELY STOPPED