The No. 1 ultrasonic sensor (front right sensor) is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the No. 1 ultrasonic sensor (front right sensor). If the No. 1 ultrasonic sensor (front right sensor) has an open circuit or other malfunction, it will not function normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE4 | Front Right Sensor Malfunction | A malfunction of the No. 1 ultrasonic sensor (front right sensor). | ·
No. 1 ultrasonic sensor (front right sensor) ·
Clearance warning ECU assembly |
If DTCs are output after repairs, turn the ignition switch to ON and turn the back sonar or clearance sonar switch assembly on. Then clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC C1AE4 is output | A |
| DTC C1AE4 and C1AEC are output | B |
| No DTCs are output | C |
A
B
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Replace the No. 1 ultrasonic sensor (front right sensor) with a known good one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front Side)>REMOVAL
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1AE4 is output | A |
| No DTCs are output | B |
A
B