Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › from 2015.04
RM19V0EQ _59 Vehicle Exterior _014623 EXTERIOR PANELS / TRIM _0074267 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  REMOVAL  


PROCEDURE

Hide 53295E 1.REMOVE COOL AIR INTAKE DUCT SEAL

a.
B400863

Remove the 9 clips and cool air intake duct seal.


Hide 2.REMOVE FRONT BUMPER ASSEMBLY

a.
B400864C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the front bumper assembly as shown in the illustration.


b.
B381229

Remove the 7 screws.


c.
B381224C01
2.104,2.24 2.104,2.073 true 2.042,2.24 2.313,2.51 0.271,0.271 10 false *1 3.083,2.188 3.406,2.49 0.323,0.302 10 false *a
*1 Pin Hold Clip
*a 90°


Using a screwdriver, turn the pins 90 degrees and remove the pin hold clip.

HINT:

Use the same procedure for the RH side and LH side.



d.

Remove the clip.

HINT:

Use the same procedure for the RH side and LH side.



e.
B400865C01
1.896,3.688 2.385,3.594 true 1.719,3.604 2,3.896 0.281,0.292 10 false *a
*a Screwdriver
V100155

Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disengage the 3 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



f.

Pull back the side of the front bumper assembly and disconnect each connector.

NOTICE:

Do not apply excessive force when separating the front bumper assembly.



g.
B400866

Using a clip remover, remove the clip and 2 hood center cushions.


h.
B400867

Remove the 2 bolts.


i.
B400868

Remove the front bumper assembly as shown in the illustration.