Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › from 2015.04
RM19V0EQ _59 Vehicle Exterior _014623 EXTERIOR PANELS / TRIM _0074267 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.
B400869

Move the front bumper assembly into position as shown in the illustration.


b.

Pull back the side of the front bumper assembly and connect each connector.

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.



c.

Install the 2 bolts.


d.

Install the 2 hood center cushions and clip.


e.
B400870

Engage the 3 claws to install the front bumper assembly as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



f.
B381225C01
1.885,2.229 1.885,2.083 true 1.833,2.26 2.104,2.542 0.271,0.281 10 false *1 2.198,1.979 2.51,2.271 0.313,0.292 10 false *a 2.927,1.99 3.302,2.292 0.375,0.302 10 false *b
*1 Pin Hold Clip
*a Correct
*b Incorrect


Install the pin hold clip as shown in the illustration.

NOTICE:

Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.


HINT:

Use the same procedure for the RH side and LH side.



g.

Install the clip.

HINT:

Use the same procedure for the RH side and LH side.



h.

Install the front bumper assembly with the 7 screws.


Hide 53295E 2.INSTALL COOL AIR INTAKE DUCT SEAL

a.

Install the cool air intake duct seal with the 9 clips.