Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER › from 2015.04
RM19V0EQ _59 Vehicle Exterior _014623 EXTERIOR PANELS / TRIM _0074268 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  REMOVAL  


PROCEDURE

Hide 52164A 1.REMOVE REAR BUMPER PLATE LH

a.
B381244C01
0.75,2.865 0.646,2.792 false 0.792,2.802 1.063,3.031 0.271,0.229 10 false *a
*a Hook
V100155

Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws.


b.

Disengage the hook and remove the rear bumper plate LH.


Hide 52163A 2.REMOVE REAR BUMPER PLATE RH

HINT:

Use the same procedure as for the LH side.


Hide 3.REMOVE REAR BUMPER ASSEMBLY

a.
B381246C02
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear bumper assembly as shown in the illustration.


b.
B381247

Remove the 2 screws.


c.
B400881C01
0,0 0,0 false
V100135

Screw
V100136

Clip


Remove the 7 screws.


d.

Using a clip remover, remove the 4 clips.


e.
B381249

Remove the screw.

HINT:

Use the same procedure for the RH side and LH side.



f.
B381250C01
1.563,3.604 1.479,3.438 true 0.26,2.479 0.49,2.719 0.229,0.24 10 false B 0.219,0.333 0.448,0.573 0.229,0.24 10 false A 1.563,3.615 1.896,3.906 0.333,0.292 10 false *a
*a Screwdriver
V100155

Protective Tape


Disengage the claw (A).

HINT:

Use the same procedure for the RH side and LH side.



g.

Using a screwdriver with its tip wrapped with protective tape, disengage the 6 claws (B) as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



h.
B381260

Disengage the 6 claws as shown in the illustration.


i.

w/ TOYOTA Parking Assist-sensor System:

i.

Disengage the 3 clamps (w/ Corner Sensor).


ii.

Disconnect the connector.



j.

Remove the rear bumper assembly.