Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER › from 2015.04
RM19V0EQ _59 Vehicle Exterior _014623 EXTERIOR PANELS / TRIM _0074268 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  REASSEMBLY  


PROCEDURE

Hide 52023 1.INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY

a.
B381257

w/o Corner Sensor:

i.

Install the rear bumper reinforcement sub-assembly with the 6 nuts.

Torque:
61 N*m (622 kgf*cm, 45 ft.*lbf)



b.
B400880

w/ Corner Sensor:

i.

Install the rear bumper reinforcement sub-assembly with the 6 nuts.

Torque:
61 N*m (622 kgf*cm, 45 ft.*lbf)



Hide 2.INSTALL REAR BUMPER SIDE SEAL LH

a.
B381253

Engage the guide and claw.


b.
B381252

Install the 2 screws.


c.

Install the rear bumper side seal LH with a new grommet.


Hide 3.INSTALL REAR BUMPER SIDE SEAL RH

HINT:

Use the same procedure as for the LH side.


Hide 52576 4.INSTALL REAR BUMPER SIDE RETAINER LH

a.
B381259

Engage the 3 claws.


b.

Engage the 3 clips to install the rear bumper side retainer LH as shown in the illustration.


Hide 52575 5.INSTALL REAR BUMPER SIDE RETAINER RH

HINT:

Use the same procedure as for the LH side.


Hide 6.INSTALL REAR BUMPER LOWER COVER

a.

Engage the 2 guides and 10 claws.

B381263


b.
B381262

Install the 2 clips.


c.

Install the rear bumper lower cover with the 2 outside moulding retainers.


Hide 89348 7.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

Hide 89341A 8.INSTALL NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

Hide 89348J 9.INSTALL ULTRASONIC SENSOR CLIP (w/ TOYOTA Parking Assist-sensor System)

Hide 10.INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)